Premium 3D Printer Filament - Glow in The Dark PLA Filament 1.75mm (Green & Blue) | High Precision +/-0.03mm | 2kg Spool for 3D Printing, DIY Projects, Cosplay Props and Nighttime Decorations

Looked great at .15mm layer height with a .4mm nozzle. The only time it doesn’t look like wood is on flat surfaces horizontal to the bed. So when I printed a mini piece of lumber the sides looked great but the top and bottom were too smooth. I tilted the piece 45 degrees and used supports and the whole thing looked perfect. I don’t think I ran my printer higher than 200 degrees for most prints. Some of the other brands I had to bump up to 210 if I wanted to run faster speeds.They need to specify Transitions for those that want the full rainbow effect.GoodThey do indeed look like silk. We love them. We have already used two full spools and will likely buy more.It is very easy to print with. I ordered the red+gold and the pink+purple. They printed very nicely and the colors are great. My main issue with it is with the red and gold, as you can see in the picture, the spool has a twist in the filament or something. This led to very noticeable lines on the t-rex. The lines are there on the fire sprite dragon as well, but with that model, it doesn't look so bad because it has flames, and where it swapped color sides worked out well. As for the pink and purple, it was much better. On the astronaut, it's tougher to see the color differences because it was top to bottom instead of side to side but that's just the way it was loaded and oriented on the bed.The red/gold was used on a Tenlog TL-D3 Pro direct drive and the pink/purple was used on an Ender 3 Pro, both with typical pla settings.Overall, pretty good filament.I got this pack specifically for the green so I could print this creeper for my son. The Filament is packaged nicely in separate, vacuum-sealed bags and needed no prep in order to print perfectly. The errors in the model shown are strictly due to my printer and not the fault of the filament.The colors look really good before printing. After printing something the colors still look good but they get somewhat dull. I have found that it works better with small prints. I have had no issues with this filament until the last couple prints had warping on the edges, but that might just be on me. I didn't really like the way the Blue+Silver and the Red+Green turned out looking. I would buy the Red+Gold and the Brozen+Silver again.print great every timeI got the glow filament for one reason, for it to glow.For over $50 I expect more than a barely there glow that doesn't last very long.I have black lights so I figured I'd just have to use the stuff made with my blacklights instead. However this glow in the dark stuff DIDN'T glow from black light like most glow things do. It didn't even glow flouresant or anything. I couldn't believe it! It would only glow a short time if I held it extremely close for a few minutes.The blue glowing color was the only nice color too. The multi color from what I could tell was really ugly and didn't work well because of the spacing between colors. My muilt colored bowl ended up Just an uglier green.Definitely sending it bpackFilament would not stick to my anycubic vyper bed. All other filament I used stuck good and printed good. Tried various settings still no luck printing with this filament.Love the color changing. Great product