ANYCUBIC 3D Printer Resin 500g - 405nm High Precision Fast Curing UV Photopolymer Resin for LCD 3D Printing (TL Green) - Ideal for Miniatures, Jewelry Making & DIY Crafts

I had originally tried the anicubic brand resin because it was the same as my anycubic mono 4k printer. It was nice and I didn't realize how good it was until I tried some of the cheaper brands. It makes sturdy prints have have just enough give as not to break easily. Supports come off well without damaging g the sculpture. I can not say this for the other brands where the models have cracked or warped during printing or removal. I had to return back to anycubic resin after wasting money and time on cheaper brands. I am new to resin printing and I was lucky to have started out with this brand for my first choice.this great resin for midgrade prints.Bought 3 bottles and already used up 1 in a day and a half it works great and will buy it again.3D Resin printingNo problem with this resin worked very good I'm new at printing so I don't know pretty much what's good or bad but I didn't have any failed prints at least not due to resin would I buy again yesOk so ill start out by saying thisits kinda my fault and the resin seems to print perfectly finenowon to my experienceWhen I bought the resin I thought the fume warnings were just there because someone was sniffing the resin like a sharpie and the fumes weren't actually that bad but after a singular print my entire apartment smelled like death for about a day and a half and I kinda just had to sit outside on the little patio area. I'm sure if you are one of those people who keeps their resin printer in its own room with a fume hood this resin is great and does its job. I however do not have any sort of fume setup and well... you already read what happened. Anyway the same company does sell plant based resin which basically doesn't smell so I would recommend getting that over getting this stuff if you're a person who just got a resin 3d printer.Cumple con lo que necesitoWorks great in my anycubic photon mono 4k printer. I will say, printing at a .05mm layer level, you can see some fine layer lines when light hits your model. This can be fixed with 4 or 5 strokes of 2000 grit sand paper. Just something to keep mind for those who will be expecting a flawless surface finish.Excellent resin with no issues, just make sure your printer is operating within the recommended ambient temp range for the resin and your resin settings are dialed in correctly with an RERF test and your build plate is correctly leveled as per the manufacturer's instruction. I have used all the colour range from Anycubic Basic resin and have had no issues plus I only use the Manufacturers slicing software supplied.