****** - Verified Buyer
4.5
Using this in a Dremel Idea Builder 3D45 and the results were great! The standard 3D45 spools come with RFID so once placed into the printer, the settings are automatically set. Because these do not have said RFID tag included, the printer prompted me to choose the material type and then the various other settings for the material such as extruder temp, heated bed temp, etc. This was no issue and I had control over each either at the printer itself or within the Dremel slicing software as well the online printer interface.The product came properly vacuum sealed and with desiccant pack included. Because of habit; once opened I placed the'filament in my DIY dry box' (semi-airtight box with loose descant) for them to properly cure and remove any moisture, however, this likely may not be needed right out of the seal. The material a day or two later was placed in the printer and not a single issue.Being hard pressed to find 'something' wrong; the only thing I could come up with is that the actual spool the filament is on, unlike the 3D45 counterparts, does not have 'holes' or spacing in the spoked areas. This makes it a bit tricky to get the spool back out of the spool holder built into the printer. I have large hands and as such could not get a grip on the edge to remove so I simply had to place a wooden stick and slide/pry out the spool some to get a grip. Overall nothing to be concerned with but something that caught me in one of those 'Ah Ha!' moments.Overall a great product and price and I will continue to purchase these spools of filament. They work great and cannot recommend enough!